Remote Control  (490-0796)   Installing Speaker Horn    Faxback Doc. # 8943
Alarm System

To mount the speaker horn, do the following:

* 1.  Select a location on the engine compartment's interior wall for
      mounting the speaker horn.  Do not choose a place where you might
      drill into your vehicle's wiring or suspension system.

Note:  Do not mount the speaker horn where it will be subjected to water
       or extreme heat.

* 2.  If necessary, start the screw holes by drilling three 1/8-inch pilot
      holes into the mounting surface.  Use the speaker horn's mounting
      bracket as a guide.

* 3.  Secure the speaker horn by inserting the supplied screws through the
      mounting bracket.

Connect The Speaker Horn Wire

Caution:  Do not connect the speaker horn directly to power.  Connect it
          only as instructed.  It is not a siren.

To connect the speaker horn with the control module, follow these steps.

* 1.  Route the speaker horn's brown two-conductor wires to the interior
      of your vehicle and to the control module's location.

Note:  Many vehicle's have holes for routing wires.  If yours does not,
       drill a 1/4-inch hole through the engine compartment's fire wall
       into your vehicle's interior.  Avoid drilling through any mechanism
       or wiring.

* 2.  Connect one of the wire's conductor's to the control module's
      Terminal 2.

* 3.  Connect the other conductor to the control module's Terminal 3.

(SMC/jlc-03/22/94)