System 1035  (130-1255)           Antennas             Faxback Doc. # 7480

When you tune to local AM and FM stations, you can use the supplied indoor
AM loop antenna and FM antennas. For better FM reception, connect an
outdoor FM antenna.

CONNECTING THE AM LOOP ANTENNA

Follow these steps to connect the supplied AM loop antenna.

1.  Assemble the AM loop antenna as shown in the manual.

2.  Unwind the antenna wires (about 3 turns).

3.  Press and hold down both AM ANTENNA terminal tabs on the back of the
    system and insert the stripped ends of the antenna's wires into the
    holes. Then, release the tabs.

4.  Position the loop antenna for the best reception. You can use the
    supplied screws to attach the antenna to the wall.

CONNECTING THE SUPPLIED FM ANTENNA

The supplied FM antenna is usually adequate for FM reception in
metropolitan areas. If FM reception is weak, disconnect the FM antenna
from the terminal on the back of the system and connect an outdoor
antenna.

If you install an outdoor antenna, follow all the installation
instructions described in the enclosed "Safety Instructions".

Use 300-ohm twin lead for this connection. Your local Radio Shack store
sells a complete line of outdoor antennas and accessories.

Follow these steps to connect an FM antenna.

1.  Press and hold down the FM ANTENNA terminal tabs on the back of the
    system.

2.  Insert the stripped ends of the antenna's wires into the holes.

3.  Release the FM ANTENNA terminal tabs.

4.  Position the antenna for the best reception.

(tlc/all-08/31/93)