Five-In-One Remote Control (150-1908)      Setup        Faxback Doc. # 6568

SETTING UP THE 5-in-1

1.  Remove the battery compartment cover and install four fresh AAA
    alkaline batteries (Radio Shack Cat. No. 23-555) as indicated by the
     polarity (+ and -) symbols marked in the compartment.

NOTE:  Do not place objects on top of the remote control after you install
       the batteries.  This can press down keys and reduce battery life.

2.  Refer to Faxback Doc. # 7162 & 7163 for the "Manufacturer's Codes" and 
    write down the codes for your original remote controls on the provided 
    label.

3.  Press the device key for the remote you are replacing (TV, VCR, CABLE,
    AUX 1, OR AUX 2).

4.  Press down and hold PROG until the red indicator blinks twice, and
    continue holding it down as you enter the 3-digit manufacturer code.

For example, to replace a Panasonic TV's remote control (manufacturer code
051), you would press:

       TV - PROG - 0 - 5 - 1

5.  When the indicator blinks twice again, release PROG.

6.  Point the 5-in-1 at your device and press POWER.  The device should
    turn on (or off, if it was on).

Repeat Steps 2-6 for additional devices.

NOTE:  The punch-through feature is automatically turned on for the TV's
       volume and mute controls.  This means that when you select CABLE
       and press one of the volume buttons or the MUTE button, the remote
       actually sends the codes to the television, and not the cable
       converter.  If you want to use your cable converter's volume and
       mute controls, disable the punch through feature for these buttons.
       See "Punch Through."


If the remote does not operate your device, try other codes listed in
"Manufacturer's Codes" for your brand of TV, VCR, cable box or other
remote-controlled device.

NOTE: When the 5-in-1's range decreases or the 5-in-1 operates
      erratically, replace the batteries.

CAUTION:  Be sure to have the fresh batteries ready to install before you
          remove the old batteries.  The 5-in-1's memory only lasts about
          a minute without the batteries.  If the memory is lost, simply
          re-enter the 3-digit codes for your remote control products.

USING TWO OR MORE SIMILAR DEVICES

Each OF THE 5-IN-1'S keys are preset to control particular devices, as
shown in the following list.

   TV - TVs Only.

CABLE - Cable converters, satellite receivers, and video accessories.

  VCR - VCRs and laser disc players.

  AUX - CD players, amplifiers, tuners, receivers, home automation
        products, miscellaneous audio products.

Normally, you program each key for one of its listed devices.  However, if
you have two or more of the same type of device (two TVs, two VCRs, and so
on) you convert any unused device key to control another type of device.

To do this, you press PROG (briefly) - 9 - 9 - 0 - unused device key - new
device key.  For example, the following key strokes convert an unused
CABLE key for use as a second VCR key.

     PROG - 9 - 9 - 9 - CABLE - VCR

To change the CABLE key back to its normal function, use the following
sequence of key strokes:

     PROG - 9 - 9 - 9 - CABLE - CABLE

(CJD/all--7/12/94)