105 MB Smartdrive (250-4130)     Addendum              Faxback Doc. # 3098

After you install the 105MB SmartDrive in your computer, you must run the 
computer Setup utility to specify the drive type.  Do not select type 12,
as is indicated in the following sections of the installation guide:

Page 5, "preparing the SmartDrive" in the "Before you Begin" section.

Page 22, "Initialization Instructions" in the "Completing the Installation".
section.

Select Any (Non-Standard type) or Other as the drive type.  After you select
Non-Standard, enter the following information:

Cylinders           755
Heads               16
Landing Zone        754
Sectors             17

Entering the above information gives the drive a formatted capacity of 
102MB or 104,615,936 bytes (1MB=1,048,576 bytes) as formatted under MS-DOS
3.3.

If the Setup utility for your computer does not support the Any (Non-
Standard type) or Other option, select Type 36.
 
Select "Y" for SmartDrive if the Setup utility for your computer has a 
SmartDrive option.

NOTICE FOR NOVELL USERS:
You must select drive type 36.  Novell does not support the Any (Non-
Standard type) or Other drive type at this time.

NOTICE FOR TANDY 3000NL USERS:
For a Tandy 3000NL, select Type 28.  This selection gives the drive a 
formatted capacity of 68MB.

(dkh-07/29/93)