WESTERN DIGITAL CORPORATION WD1002S-WX2 Data bus: 8-bit, PC/XT Size: Full-length, half-height card Hard drives supported: Two MFM ST506/412 drives Floppy drives supported: None [Image] CONNECTIONS Function Location 34-pin control cable connector-hard drive J1 20-pin data cable connector-drive 0 J2 20-pin data cable connector-drive 1 J3 USER CONFIGURABLE SETTINGS Function Location Setting Reserved for BIOS SW1/8 open Reserved for BIOS SW1/7 open Reserved for BIOS Virtual SW1/6 open option Reserved for BIOS Auto-config SW1/5 open option » Normal operation W1 pins 1 & 2 closed Factory test W1 pins 2 & 3 closed » Normal operation W2 pins 1 & 2 closed Factory test W2 pins 2 & 3 closed » BIOS enabled W3 closed BIOS disabled W3 open » I/O port address 320h W4 pins 2 & 3 closed I/O port address 324h W4 pins 1 & 2 closed » BIOS size 32K or 64K W5 pins 1 & 2 (hard-wired) closed BIOS size 16K W5 pins 2 & 3 closed » 8 Head hard drive with RWC W6 pins 2 & 3 supported closed 16 head hard drive supported W6 pins 1 & 2 (Head Select 3) closed » Hard Drive Interrupt is IRQ5 W7 pins 1 & 2 (hard-wired) closed Hard Drive Interrupt is IRQ2 W7 pins 2 & 3 closed BIOS DRIVE TYPE TABLE - SW1 JUMPERS 1 AND 2 CONFIGURE DRIVE 1 JUMPERS 3 AND 4 CONFIGURE DRIVE 0 # Jumper 1 Jumper 2 Cap. Hds. Cyls. WP RWC & 3 & 4 0 closed closed 21MB 4 612 613 613 1 open closed 10MB 2 612 128 128 2 closed open 21MB 4 612 128 613 3 open open 10MB 4 306 all 306 (0) MISCELLANEOUS TECHNICAL NOTES This controller has a built-in low-level format program. To enter the program run the DEBUG utility supplied with DOS and at the prompt enter: G=C800:5.
Hello this is a test!